MRAM - SPI
General Description
The device is a Spin-Transfer-Torque Magneto-resistive
Random Access Memory (STT-MRAM). It features a SPI bus interface,
XIP(execute-in-place) functionality, and hardware/software-based data
protection mechanisms. SPI (Serial Peripheral Interface) is a synchronous
serial communication interface with command, address and data signals. It
requires fewer pin counts than parallel interface and is easy to be configured
on the system. The device can replace Flash, FRAM or (nv)SRAM with same
functionality and non-volatility.
Features
Supports Serial Peripheral
Interface with Mode 0 and Mode 3- Single SPI (1-1-1, 1-1-2,
1-2-2, 1-1-4, 1-4-4) - Dual SPI (2-2-2) - Quad SPI (4-4-4)
Operating Frequency - Single Data
Rates (SDR) : 108MHz - Double Data Rates (DDR) : 54MHz
Supports XIP for read and write
operations
Fast write time and single byte
writable
Data protection - WP pin write
protection - Block lock protection
Nonvolatile status and
configuration registers
Identification - 64-bit unique ID
- 64-bit serial number - user writable
Augmented 256-byte
nonvolatile-area- Read and write with user-protection
Deep power down for low power
Supports JEDEC reset
Memory cell: STT-MRAM
Density - 1Mb, 2Mb, 4Mb, 8Mb and
16Mb
Data Integrity: No external ECC
required
Data Endurance - Unlimited read
cycle - 1014 write cycles
Data Retention - 10 years at 85°C
Single Power Supply Operation
Operating Temperature Range -
Commercial Temperature: 0°C to 70°C - Industrial Temperature : -40°C to 85°C
RoHS compliant packages - 8L WSON
(5.0mm x 6.0mm) - 8L SOIC (150mil)